【 文字大小:   】  【 关闭窗口

Band sawing machine daily maintenance coup

发布日期:2015-5-12 15:33:00  点击数:1286

Teach you a few band sawing machine daily maintenance coup

Band sawing machine maintenance before operation, based on the work program to check the following.

1) check the position of chip brush machine, keep clear, teeth and filings when necessary, adjust or replace the chip brush. Check chip steel brush height, the steel brush just touches the bottom of the sawtooth. Can not be higher than the bottom of the sawtooth, this will cause the band saw or excessive wear of the steel brush.

2) check the gear box and hydraulic oil box sawing machine table position, whether you need to add gear oil, hydraulic oil 32# 150#;

3) check the cooling water table height saw whether you need to add;

4) check whether the main band sawing machine, a driven wheel and guide the correct position of tungsten steel;

5) check the saw belt tension adjusting valve, selecting the appropriate cutting pressure; the maximum tension band for 55klbs/in2 HSS

6) check the oil pressure gauge pressure in 30+2kg/cm2 steel sawing machine;

7) check the gear box tension belt sawing machine;

8) the installation of a new band saw, sawing machine, passive wheel flange will be the main iron clean (iron accumulation may).

上一条:选择红运锯床的三个理由  下一条:带锯床的日常保养妙招
Copyright©浙江红运锯床有限公司 All Rights Reserved.